Skip to main content

Telomere PNA FISH

Measuring Telomere Length by PNA FISH: Q-FISH and Flow-FISH

Telomere length is read out as brightness. A fluorescently labelled probe is hybridised to the telomere repeat, and the integrated fluorescence of each spot is taken as proportional to the number of repeats beneath it. The method is called quantitative FISH, or Q-FISH, and the probe that made it practical is a peptide nucleic acid rather than an oligonucleotide. This page explains why the probe is PNA, how the intensity is converted into kilobases, and the two places where the number quietly goes wrong.

Three panels showing a telomere PNA probe hybridised to the ends of a metaphase chromosome, the integration of each signal into a fluorescence intensity, and calibration of that intensity into kilobases using references of known repeat number.
Q-FISH does not count telomeres, it weighs them. The quantity that carries the biology is the distribution of lengths across chromosomes, not the average alone.

Why the probe is PNA

A telomere is a tandem repeat of TTAGGG on one strand and CCCTAA on the other, and the obvious probe is a short complementary oligonucleotide. The difficulty is that the chromosomal target is double-stranded. After denaturation, the two telomeric strands are present in enormous local excess over any probe you add, and they reanneal with each other far faster than a DNA probe can compete for them. A DNA probe therefore reports a small and variable fraction of what is actually there.

PNA changes the competition. Because the backbone carries no phosphate charge, there is no electrostatic repulsion between probe and target, so hybridisation is both faster and tighter than the equivalent DNA duplex1,2. More usefully, PNA hybridisation is largely independent of ionic strength, which means the reaction can be run at a salt concentration low enough that the two genomic strands do not readily reanneal, while the PNA still binds2,3. The probe is allowed to win a race that a DNA oligonucleotide would lose.

The same chemistry sharpens mismatch discrimination, although the size of the penalty is not a single number. In a systematic survey of an 11-mer PNA against complementary DNA carrying every possible single-base mismatch at every position, the loss in melting temperature exceeded 20 °C for the least tolerated placements, and depended on both where the mismatch sat and which bases were involved: G:T and T:T were the most tolerated pairings, A:A and G:G the most destabilising4. For a tandem repeat that discrimination matters less than it does for a point mutation, but it is the same property that makes PNA the preferred chemistry for the clamping and genotyping applications described elsewhere in this centre.

Probe chemistryPNA, because the neutral backbone permits low-salt hybridisation that suppresses reannealing of the genomic strands
TargetThe TTAGGG tandem repeat at chromosome ends
Common probesA C-rich probe such as (CCCTAA)3, which binds the G-rich strand; a G-rich probe binds the complementary strand
Read-outIntegrated fluorescence per spot, not spot count
ResolutionReported at the level of a few hundred base pairs for single-chromosome measurements5

Q-FISH on metaphase spreads

The original method hybridises a fluorescein-labelled (CCCTAA)3 PNA probe to fixed metaphase cells and measures the result by digital fluorescence microscopy5,6. Each chromosome contributes four signals, one at each chromatid end, and each is integrated separately. The output is therefore not a single number for the cell but a distribution across chromosome arms, which is the method's main advantage over a bulk measurement such as the telomere restriction fragment Southern blot.

That distinction turns out to matter biologically. The frequency of very short telomeres, rather than the mean length, is the quantity most often associated with telomere dysfunction7. A population whose average looks unremarkable can still contain the small number of critically short ends that drive a phenotype, and a bulk method will not show them.

Flow-FISH when you need cells, not chromosomes

Hybridising the same PNA probe in suspension and reading the fluorescence by flow cytometry gives the average telomere length per cell across thousands of cells, which is the approach known as flow-FISH. It was first applied to human lymphocyte subpopulations8 and has since been described in protocol form in detail9.

A quantitative flow variant using a fluorescein-labelled (CCCTAA)3 PNA probe with propidium iodide DNA counterstaining was reported to give results within about 30 hours with high reproducibility, and its telomere length values correlated significantly with Southern blotting10. The same work notes a practical point worth copying: an internal cell line control included in every run compensates automatically for variation between hybridisations10. Because DNA content is measured at the same time, the signal can be resolved by cell cycle phase10.

Where the number goes wrong

Two failure modes account for most unreliable telomere data, and neither is visible in the image.

  • Saturation. If the brightest telomeres drive the detector into saturation, their integrated intensity stops increasing with repeat number and the longest telomeres are recorded as shorter than they are7. Exposure has to be set so that the brightest signal in the sample is still on the linear part of the response, which usually means setting it on the longest-telomere control rather than on a typical field.
  • Uncalibrated intensity. Fluorescence in arbitrary units is not a length. Converting it requires references imaged under identical conditions — cells or plasmids carrying a known number of telomere repeats7. Exposure, gain, lamp output, filter set and even the batch of probe all shift the scale, so calibration belongs in the same session as the samples, not in a previous one.

Comparisons between laboratories, or between experiments months apart, are only meaningful if both carried their own calibration. A telomere length quoted in kilobases without a stated reference is an intensity measurement wearing different units. Practical guidance on these pitfalls has been published alongside the methods themselves11.

Choosing the probe for the strand you want

ProbeSequenceBindsTypical use
TelCCCCTAACCCTAACCCTAAThe G-rich strandThe standard choice for Q-FISH and flow-FISH
TelGTTAGGGTTAGGGTTAGGGThe C-rich strandStrand-specific work, including CO-FISH designs

Both are stocked as labelled PNA probes; see PNA probes, inhibitors and selected products. Fluorophore choice follows the usual imaging constraints rather than anything particular to PNA — a far-red dye such as Cy5 keeps the telomere signal clear of tissue autofluorescence, while fluorescein is the historical choice and the one most published calibrations were built on. The dye table on the PNA synthesis and conjugation page lists excitation and emission maxima for the labels we routinely attach.

Related reading

Ordering a telomere probe

Tell us the strand you need to detect, the fluorophore your filter set is built around, and whether the probe is for metaphase imaging or for hybridisation in suspension. If you are setting up calibration for the first time we can also supply the complementary strand probe so that both are from the same synthesis.

References

  1. Egholm M, Buchardt O, Christensen L, Behrens C, Freier SM, Driver DA, Berg RH, Kim SK, Nordén B, Nielsen PE. PNA hybridizes to complementary oligonucleotides obeying the Watson-Crick hydrogen-bonding rules. Nature 1993;365(6446):566–568. doi:10.1038/365566a0
  2. Hyrup B, Nielsen PE. Peptide nucleic acids (PNA): synthesis, properties and potential applications. Bioorganic & Medicinal Chemistry 1996;4(1):5–23. doi:10.1016/0968-0896(95)00171-9
  3. Williams B, Stender H, Coull JM. PNA fluorescent in situ hybridization for rapid microbiology and cytogenetic analysis. Methods in Molecular Biology 2002;208:181–193.
  4. Igloi GL. Variability in the stability of DNA–peptide nucleic acid (PNA) single-base mismatched duplexes: real-time hybridization during affinity electrophoresis in PNA-containing gels. Proceedings of the National Academy of Sciences USA 1998;95(15):8562–8567. doi:10.1073/pnas.95.15.8562
  5. Poon SSS, Lansdorp PM. Quantitative fluorescence in situ hybridization (Q-FISH). Current Protocols in Cell Biology 2001;Unit 18.4. doi:10.1002/0471143030.cb1804s12
  6. Lansdorp PM, Verwoerd NP, van de Rijke FM, Dragowska V, Little M-T, Dirks RW, Raap AK, Tanke HJ. Heterogeneity in telomere length of human chromosomes. Human Molecular Genetics 1996;5(5):685–691.
  7. Poon SSS, Martens UM, Ward RK, Lansdorp PM. Telomere length measurements using digital fluorescence microscopy. Cytometry 1999;36(4):267–278.
  8. Rufer N, Dragowska W, Thornbury G, Roosnek E, Lansdorp PM. Telomere length dynamics in human lymphocyte subpopulations measured by flow cytometry. Nature Biotechnology 1998;16(8):743–747.
  9. Baerlocher GM, Vulto I, de Jong G, Lansdorp PM. Flow cytometry and FISH to measure the average length of telomeres (flow FISH). Nature Protocols 2006;1(5):2365–2376. doi:10.1038/nprot.2006.263
  10. Hultdin M, Grönlund E, Norrback K, Eriksson-Lindström E, Just T, Roos G. Telomere analysis by fluorescence in situ hybridization and flow cytometry. Nucleic Acids Research 1998;26(16):3651–3656.
  11. Baerlocher GM, Mak J, Tien T, Lansdorp PM. Telomere length measurement by fluorescence in situ hybridization and flow cytometry: tips and pitfalls. Cytometry 2002;47(2):89–99.

Sequences supplied by customers are treated as confidential and are never disclosed or reused.

All LifeTein products are supplied for laboratory research use only. They are not for human or veterinary use, and not for diagnostic or therapeutic use.